Overview

After OpenNebula Front-end is correctly setup the next step is preparing the hosts where the VMs are going to run.

How Should I Read This Chapter

Make sure you have properly installed the Front-end before reading this chapter.

This chapter focuses on the minimal node installation you need to follow in order to finish deploying OpenNebula. Concepts like storage and network have been simplified. Therefore feel free to follow the other specific chapters in order to configure other subsystems like networking and storage.

Note that you can follow this chapter without reading any other guides and you will be ready, by the end of it, to deploy a Virtual Machine. If in the future you want to switch to other storage or networking technologies you will be able to do so.

After installing the nodes and verifying your installation, you can either start using your cloud or configure more components:

  • Authenticaton. (Optional) For integrating OpenNebula with LDAP/AD, or securing it further with other authentication technologies.
  • Sunstone. OpenNebula GUI should working and accessible at this stage, but by reading this guide you will learn about specific enhanced configurations for Sunstone.

Hypervisor Compatibility

Section Compatibility
KVM Node Installation This Section applies to KVM.
LXD Node Installation This Section applies to LXD.
vCenter Node Installation This Section applies to vCenter.
Verify your Installation This Section applies to vCenter, KVM and LXD.

If your cloud is KVM or LXD based you should also follow:

Otherwise, if it’s VMware based: